There is nothing more comforting than a bowl of homemade macaroni and cheese. Let’s face it, many of us are cooking A LOT more than we normally do during the stay-at-home orders. So, what better dish to make than a medicated macaroni and cheese for us medical marijuana patients! This recipe from Cooking with Laurie and Mary Jane is definitely a winner! Add your favorite toppings such as, bacon or broccoli, and enjoy your bowl of soothing comfort!
If you think you may be a candidate for medical marijuana, contact us today using the form below.
Over the last few weeks, we’ve been getting lots of questions about how to make edibles at home. Some of our patients are looking to consume edibles in lieu of smoking during the COVID-19 pandemic. To help, we’ve put together some helpful tips to help you accomplish this at home! First we will go over decarboxylation and then making the cannabutter.
Decarboxylation is a step you cannot skip when you cook with cannabis. The decarboxylation process involves applying low heat for an extended period of time to convert cannabis’ non-intoxicating THCA into THC (the cannabinoid in cannabis known for its psychoactive effects.) Failure to do this will result in weak or less effective edibles.
How to decarboxylate weed
- Preheat your oven to 240°F.
- Break apart any large buds with your hands.
- Spread the cannabis on a baking sheet with sides.
- Place in the oven.
- Remove from oven after about 45 minutes.
Making the Cannabutter
Next, you will make a cannabutter to use in your recipes! This calls for 4 sticks butter and 1 ounce shake, finely ground and decarboxylated cannabis.
- In a medium saucepan, bring a quart of water to a boil. You can vary the amounts, just be sure that the marijuana is always floating about 1 ½ to 2 inches from the bottom of the pan.
- When the water is boiling, place the butter in the saucepan and allow it to melt completely. Once the butter has melted you can add the marijuana.
- Once the marijuana is added the heat should be turned down, very low, to barely a simmer. We usually let it cook for around 3 hours. You can tell it’s done when the top of the mix turns from really watery to glossy and thick.
- While the cannabutter is cooking, set up the bowl to hold the finished product. There are a couple of ways to do the straining (a fine mesh strainer lined with cheesecloth. You can also tie a double layer of cheesecloth around a large heatproof bowl with twine, making it taut across the top).
- Strain the marijuana butter over the bowl, being careful not to spill. When the saucepan is empty, carefully undo the twine, pick up the cheesecloth from all four sides, and squeeze out all of the remaining butter.
- Allow the cannabutter to cool at room temperature for about an hour. Place in the fridge until the butter has solidified and separated from the water. The THC and other properties have attached to the butter, and you are just about there.
- Run a knife around the edge and lift the butter off the water. Place upside down on your work surface and scrape off any of the cooking water. Your cannabutter is ready to be used. Store in the refrigerator or freezer in an airtight container.
This recipe uses 4 sticks of butter to every ounce of marijuana, so if you’re using a half ounce of weed that’s about 2 sticks of butter and so on.
Check back for more updates and recipes! Don’t forget to like our page on Facebook and share with your network! If you think you are a candidate for medical marijuana, contact us using the form below or call us now.
In order to gain access to the world of benefits that medical marijuana has to offer, you’ll first need to get a state-issued identification card. This card proves to marijuana dispensaries that you have an approved condition in New Jersey, and that a physician has provided written certification that you may benefit from the use of medical marijuana. Here are some benefits of getting a New Jersey medical marijuana card.